Pour guidon de 7/8" (22mm) de diamètre.Tirage non compris. La Paire.

 

CE POIGNEES NE CONVIENNENT PAS aux Harley Davidson ou autres marques équipés des commandes d'origine et/ou pour guidon de 1" / 25.40mm  de diamètre.

 

Les poignées de motos devraient être simples et confortables. Et c’est exactement le cas de ces exemplaires issus de l’univers du BMX. Un peu plus épaisses à l’extrémité, une petite collerette au niveau des commandes et de nombreuses petites lamelles. Voilà qui assure une bonne brise et un vrai confort.

Construction: Injection-molded Krayton synthetic rubber

 

 

Fitment: Biltwell grips are available in two sizes: 7/8” and 1”. Each size number refers to the outside diameter of the bar end on the left side of your motorcycle. If you don’t know the O.D. of your handlebars, measure with a caliper, an open-end wrench or other device. Each set comes with two grips: one for the clutch side (small inside diameter) and one for the throttle (larger I.D.) Installing the wrong grip on either side may result in loose-fitting grips or grips that can tear and stretch too far during installation. If any of this information seems overly simplistic, it is only because we get a lot of questions from guys who say they have never installed grips. Hard to believe, but true.

 

Details: Click Tips & Tricks for complete instructions on how to install Biltwell grips. NOTE: Using Kung Fu grips on H-Ds requires that your motorcycle is equipped with an aftermarket throttle (our Whiskey throttle, for instance).